The computer will not turn on but will not boot

The problem that often arises is that the computer will not turn on but will not boot
Usually after pressed the power button, the computer life. Power-on indicator is also visible flame. But after waiting a long time, the computer operating system and the computer does not immediately activated immediately stopped in mid-process.


For solving the problem is to watch carefully, whether the condition dark screen and computer beeps repeatedly. If yes, then it's a sign that you will soon detect the errors that exist on your computer. Beep is a sign that the BIOS installed on the motherboard to POST (Power On Selft Test) when the computer is turned on da successfully detected a fault.

Listen to how that sounds beeps on your speakers. As the example below, a list of the beep happens AWARD BIOS model that shows the condition code on your computer.
Table 1. List beep and mean

If it is number 4 or 5, maybe you should immediately take your computer to place a reliable service. But if that appears is the number 2 or 3. You can try to overcome the damage to the following actions:1. you turn off the computer, turn off the stabilizer, unplug all cables, and then open the casing. Bring your PC to place the light, or provide a flashlight to help you see more clearly into it.2. If detected is beep to mark the memory of damage, you can check the memory card if it is plugged into the correct slot. Since this is often the cause. Books latch, pull memorynya card, plug it back in correctly. Do not forget to lock the slot. Also make sure your memory is in good condition, no defects and are not damaged.3. If detected is beep VGA Card with signs of damage, you can check the position of the VGA card in its slot if it is properly installed, if necessary, re-open and pasarng card.4. Once only, make sure the cards and kebel-wiring in the PC is plugged in, and do not have disabilities or even drop continued. The principle is that the computer running well, then all components must be in the correct position and in good condition too.5. Simultaneously check that your motherboard is not scratched. Copper lines are still good and not be cut by sharp objects incision.6. If you are sure that the RAM and VGA card is installed correctly, try restarting your computer.7. If it turns out the case is still the same, try to swap the location of the memory card or the VGA card to another slot. Can also damaged the slot. Then do the test by restarting the computer.8. If not done well, consult a computer technician service your subscription.Please note that this code BIOS beep on every brand is different and sometimes it is not always consistent in presenting information. But until now the most commonly used method to diagnose the computer without having to open or use the software diagnosis.